Product Requirements
Product type, dimensions, density, compressive-strength target, surface finish, joints and reinforcement requirements.
PRODUCTS
Lightweight Block & Wall Panel Products
Start with one of two product families. Compatible products and process routes are then reviewed against the building use, local materials and required factory output before equipment is selected.
Independent engineeringEquipment manufacturingProject delivery
REAL HENGDE FACTORYProduction equipment configured around the intended wall product
HENGDEProject-specific configuration
2Product families
12Compatible product types
Product firstSelection principle
01
TWO PRODUCT FAMILIES
Choose the family that matches the target wall product
REAL PRODUCT MEDIA Lightweight Blocks
Square-mould platform production lines organized around lightweight block products, a verified process route, project capacity, BOM and linked equipment.
- CLC Blocks
- NAAC Blocks
- Foam Concrete Blocks
- EPS Self-Insulating Blocks
- Ceramsite Lightweight Blocks
- Other Lightweight Blocks
REAL PRODUCT MEDIA Lightweight Wall Panels
Long-mould platform production lines organized around the target wall-panel product, verified process route, project capacity, BOM and linked equipment.
- Lightweight Wall Panels
- Foam Concrete Wall Panels
- EPS Composite Wall Panels
- Ceramsite Wall Panels
- Self-Insulating / Composite Wall Panels
- Special Wall Panel Products
02
PROJECT INFORMATION
Information Required for Production-Line Selection
Raw Materials
Cement or binder, sand, stone powder, fly ash, tailings, EPS, ceramsite and other available materials.
Production Process
Physical foaming, chemical aeration, moulding, curing, cutting and handling requirements.
Factory Requirements
Target output, operating hours, mould cycle, curing time, available power and water, workshop space and site logistics.
DISCUSS YOUR PROJECT
Discuss Your Project Planning a Lightweight Block or Wall Panel Project?
Tell us what you plan to produce and where the factory will be built.
Test local materials before final line configuration
HENGDE can evaluate locally available raw materials before finalizing the process and equipment configuration.
Start with representative samples
Review locally available materials against the target product before production equipment is selected.
Recycled or variable inputs require source-specific testing and trial production.
Adjust the process after testing
Test results guide material ratios, dosing, mixing, forming, curing and finishing requirements.
Final formulation and equipment follow the actual materials and required product.